That's it - you've got the access to your signal and fog lamps. I guess I need to replace fuel level sensor now. From there on is just a side terminal battery, 8mm wrench for the side terminals and a 13mm for the hold down bolt. Push the center pins all the way in to secure. Also important is whether the code is History or Current. I think I'll just go with the fuel level sensor and deal with the fuel pump when needed.
The fact that its a northern car won't help either. If not, then post your question. You will have to remove plastic clips on the sides of that shield. The good news its accessible from the trunk, don't have to drop the tank. Sorry I left out the most important item. Open the ash tray and remove the felt lined insert, behind it is a bolt you need to remove.
Remove the two mounting screws from the. Above the radio you will need to pop out the ac vent, it … isn't screwed in so you just have to pull on it and it will pop out. These guys can help you. Fuel lines are clearly mark, unless some on has changed them. It gets dirty and worn out and needsto be replaced from time to time.
I still keep current with the latest automotive technology. Those and the help of alot of good folks here will be the ticket to making the best decisions you can when repair time comes. Ya, it was a recall back in 2003. I probably would have paid a small fortune before I got out. Open the trunk using the trunk button on the remote. .
The seat is mounted on these tracks, and a central rail that is held to the seat. Well my mechanic said it was because my exhaust system was bad. Pull the old bulb from the bulb socket keeping the. Reverse the steps to reinstall the lamp assembly. If anyone can give me a quick answer, like yes, no or never heard of that. I had everything cleaned and everything was good for a week then the engine light would go on and off, I think I may need a new sensor for the idol control or replace it.
Worse yet he found chewed up and a partially missing wire for the sensor. The large piece of floppy plastic covering the bottom of the car behind the bumper and part of the wheel wells must be partially removed to gain access. Turn the bulb socket one-quarter turn. They only ran that engine for a year and started using the 3. Be careful not to brake clips.
I cleared the code and waiting to see if it comes back. Im directing you to a website: www. I have to say the '94 was a much better riding car than the '98. Frank, Before you replace anything, check with your dealer. I use this forum everyday.
First ,turn your wheels to the max left if you replacing left side bulb. With the plastic sheet loosened, you can reach in from the wheel well and access the turn signal sockets. Then, remove the screws T20's, or Phillips , and then lift, and remove the track guards. Just picked up something called Rampage all weather Bait Chunx which I will now put under the hood, in the trunk, and in the door wells. Reinstall the sockets with a quarter turn.
With that done, I now have my State Inspection and no Service Engine light. Remove the 4 bolts and the radio will slide out. From there just reverse the steps and you are all set. Trying to decide if I should replace my Fuel Level Sending unit immediately or at a later date. The seat is bolted to the floor in four places. Once all six clips pulled out,plastic shield will almost fall by itself - no efforts needed to detach it.
Inside the arch you'll see that it is … covered by plastic shield. Disconnect the electrical connections for the fuel pumps and the fuel level sensor. The pump is a crap shoot. You will have to get both hands into the work space because the wires are too short to pull the sockets all the way out. One for the side air bag, one for the seat heater, and one for the seat belt switch showing that the seat belt is engaged.